Ford Taurus Owners Manual: Vehicle certification label

The National Highway Traffic Safety


The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certification Label may be located. The Safety Compliance Certification Label shall be affixed to either the door hinge pillar, the door latch post, or the edge of the door near the door latch, next to the driver’s seating position.

    Vehicle identification number
    The vehicle identification number is located on the driver’s side instrument panel. Please note that in the graphic, XXXX is representative of your vehicle identification number. The Vehic ...

    Transmission code designation
    You can find a transmission code on the Safety Compliance Certification Label. The following table tells you which transmission each code represents. ...

    Other materials:

    Power Steering
    SPECIFICATIONS Torque Specifications a Refer to the procedure for the specification. REMOVAL AND INSTALLATION Steering Gear Special Tool(s) NOTE: 3.5L GTDI engine shown, 3.5L Ti-VCT, 3.7L Ti-VCT and 2.0L GTDI similar. Removal All vehicles If in ...

    Specifications, Description and Operation, General Procedures
    SPECIFICATIONS Material General Specifications Torque Specifications a Tighten to 10 Nm (89 lb-in) plus an additional 720 degrees. b Tighten to 16 Nm (142 lb-in) plus an additional 180 degrees. c Refer to the procedure in this section. d Tighten to 5 Nm (44 lb-in) plus ...

    Starting and Stopping the Engine
    GENERAL INFORMATION WARNING: Extended idling at high engine speeds can produce very high temperatures in the engine and exhaust system, creating the risk of fire or other damage. WARNING: Do not park, idle, or drive your vehicle on dry grass or other dry ground cover. The emission system heats ...