Technical specifications

Wheel Lug Nut Torque Specifications WARNING: When a wheel is installed, always remove any corrosion, dirt or foreign materials present on the mounting surfaces of the wheel or the surface of the wh ...

Part numbers

1 Refer to scheduled maintenance information for the appropriate intervals for changing the spark plugs. Note: Replace the spark plugs with ones that meet Ford material and design specification ...

Other materials:

General Procedures, Removal and Installation
GENERAL PROCEDURES Wiper Blade and Pivot Arm Adjustment Cycle and park the windshield wipers. Verify that the RH and LH wiper blade tips are aligned to the "I" marks on the lower windshield glass. NOTE: Make sure there is no mechanical binding in the linkage preventing the wiper arm ...

Engine coolant check
Checking the Engine Coolant The concentration and level of engine coolant should be checked at the intervals listed in Scheduled Maintenance Information. Note: Make sure that the level is at the FULL COLD level or within the COLD FILL RANGE in the coolant reservoir. Note: Coolant expands wh ...

Specifications, Description and Operation, General Procedures
SPECIFICATIONS Material General Specifications Torque Specifications a Tighten to 10 Nm (89 lb-in) plus an additional 720 degrees. b Tighten to 16 Nm (142 lb-in) plus an additional 180 degrees. c Refer to the procedure in this section.d Tighten to 5 Nm (44 lb-in) plus a ...