Vehicle certification label

The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certificati ...

Accessories

For a complete listing of the accessories that are available for your vehicle, please contact an authorized dealer or visit our online store at www.Accessories.Ford.com (United States only). Ford ...

Other materials:

Disassembly and Assembly of Subassemblies
Transaxle Case Special Tool(s) Exploded View Disassembly Special Tool(s): Remover/Installer, Front Wheel Hub 204-069 (T81P-1104-C), Transfer Gear Bearing Race Remover 307-577 Punch a hole in the fluid dam. Center punch. General Equipment: Dent Puller Special Tool(s): Dif ...

Removal and Installation
Seat - Front NOTE: Refer to the installation steps for tightening sequence and torque specification. NOTE: Passenger seat shown, driver seat similar. Removal NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to ...

Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds): 1. Turn the ignition off. 2. Turn the lighting control to the autolamp position. ...