- Specifications, Description and Operation
- Diagnosis and Testing
- General Procedures
- Removal and Installation
- Disassembly and Assembly
Removal and Installation
Exterior Mirror
Removal and Installation
NOTE: Do not remove the exterior mirror assembly when repairing an
individual part. Individual components can be installed without removing the
exterior ...
Specifications, Description and Operation
SPECIFICATIONS
Torque Specifications
a Refer to the procedure in this section.
DESCRIPTION AND OPERATION
Seating
Front Seats
The front seats can be equipped with the following systems:
Manual ...
Other materials:
Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three
minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6
must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting control to the autolamp position.
...
Diagnosis and Testing
Automatic Transmission
Special Tool(s)
Material
DTC Chart
Diagnostics in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. Refer to Diagnostic Methods in Section
100-00 for information about these practices.
When the electrical connector ...
Safety Belts
PRINCIPLES OF OPERATION
WARNING: Never let a passenger hold a child on his or her lap
while your vehicle is moving. The passenger cannot protect the
child from injury in a crash.
WARNING: It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a crash, people ridin ...
