- Specifications, Description and Operation
- Diagnosis and Testing
- General Procedures
- Removal and Installation
Bumpers
SPECIFICATIONS
Torque Specifications
REMOVAL AND INSTALLATION
Bumper Cover - Front
Removal
With the vehicle in NEUTRAL, position it on a hoist. For additional
information, refer to Section 1 ...
Specifications, Description and Operation
SPECIFICATIONS
Torque Specifications
DESCRIPTION AND OPERATION
Safety Belt System
WARNING: All
safety belt components must be inspected and corrected as part of any collision
repair. Inspect ...
Other materials:
General Procedures
Clockspring Adjustment
WARNING: If
the clockspring is not correctly centralized, it may fail prematurely. If in
doubt, repeat the centralizing procedure. Failure to follow these instructions
may increase the risk of serious personal injury or death in a crash.
NOTE: Typical SCCM&n ...
Removal and Installation
Hood Latch
Removal and Installation
Remove the upper radiator sight shield.
Remove the 8 screws.
Remove the 4 bolts.
Remove the 2 pin-type retainers.
NOTE: Mark the position of the hood latch prior to removing the
hood latch bolts.Remove the 2 bolts and position t ...
Auxiliary Power Points
WARNING: Do not plug optional electrical accessories into the
cigarette lighter socket (if equipped). Improper use of the lighter
can cause damage not covered by your warranty, and can result in fire
or serious injury.
Note: If used when the engine is not running, the battery will
discharge.
...
