Removal and Installation

Selector Lever Cable - Floor Shift Removal All vehicles With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02. NOTICE: Failure to use a piece of c ...

Four Wheel Drive (4WD) Systems

DESCRIPTION AND OPERATION All Wheel Drive (AWD) Systems The AWD system consists of the following: PTU Rear driveshaft AWD relay module Rear axle with ATC solenoid Torque ...

Other materials:

Specifications, Description and Operation
SPECIFICATIONS Torque Specifications a Refer to the procedure in this section. DESCRIPTION AND OPERATION Seating Front Seats The front seats can be equipped with the following systems: Manual seat track Power seat track Manual recliner Power recliner Manual lumbar adjust Power lumbar ad ...

Removal and Installation
Exterior Mirror Removal and Installation NOTE: Do not remove the exterior mirror assembly when repairing an individual part. Individual components can be installed without removing the exterior mirror. Remove the sail panel. Pull outward on the sail panel to release the retaining clips. ...

General Procedures
Air Conditioning (A/C) Clutch Air Gap Adjustment Check the A/C clutch air gap at 3 equally spaced places between the clutch plate and the A/C clutch pulley. Remove the clutch plate. Add or remove spacers between the clutch plate hub and the compressor shaft until the clearance is within ...