- Specifications, Description and Operation
- Diagnosis and Testing
- General Procedures
- Removal and Installation
Removal and Installation
Antenna - Satellite Radio
Removal and Installation
NOTE: This procedure applies to both the stand-alone satellite radio
antenna and the combination satellite radio/Global Positioning System (G ...
Specifications, Description and Operation
SPECIFICATIONS
Torque Specifications
DESCRIPTION AND OPERATION
Information and Entertainment System
Component Location
Overview
The audio system consist of a 7 speaker system, with an AM/FM single ...
Other materials:
Removal and Installation
Headlamp Assembly
Removal
Remove the front bumper cover. Refer to Section 501-19.
Remove the headlamp assembly upper bolt.
To install, tighten to 3.2 Nm (28 lb-in).
Remove the headlamp assembly front bolt.
To install, tighten to 3.2 Nm (28 lb-in).
Remove the headlamp ...
Removal and Installation
Selector Lever Cable - Floor Shift
Removal
All vehicles
With the vehicle in NEUTRAL, position it on a hoist. Refer to Section
100-02.
NOTICE: Failure to use a piece of cardboard between
the LH center console lower trim panel and the center console can resul ...
Diagnosis and Testing
Airbag and Safety Belt Pretensioner Supplemental Restraint System (SRS)
DTC Charts
The DTCs can be retrieved from the RCM and the OCSM with a scan tool via
the DLC.
Restraints Control Module (RCM) DTC ChartNOTE: Always make sure the correct SRS component is b ...
