Engine block heater

WARNING: Failure to follow engine block heater instructions could result in property damage or physical injury. WARNING: Do not use your heater with ungrounded electrical systems or two-pronged (ch ...

Safety precautions

WARNING: Do not overfill the fuel tank. The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. WARNING: The fuel system may be under pressure. If you hear a hissing s ...

Other materials:

Using This Manual
Introduction This manual describes and directs repair procedures specified by Ford Motor Company for the vehicle. Critical health and safety precautions are included. Anyone who deviates from these instructions risks compromising personal safety or vehicle integrity. SECTION CONTENT This manual ...

Installation
Engine Special Tool(s) Material All vehicles Using the Floor Crane and Spreader Bar, align the transaxle to the engine. Align the transaxle to the engine and install the 5 transaxle-to-engine bolts. Tighten to 48 Nm (35 lb-ft). Install the 2 engine-to-transaxle bolts. ...

Engine coolant check
Checking the Engine Coolant The concentration and level of engine coolant should be checked at the intervals listed in Scheduled Maintenance Information. Note: Make sure that the level is at the FULL COLD level or within the COLD FILL RANGE in the coolant reservoir. Note: Coolant expands wh ...