Auxiliary Power Points

WARNING: Do not plug optional electrical accessories into the cigarette lighter socket (if equipped). Improper use of the lighter can cause damage not covered by your warranty, and can result in fir ...

Center console

Stow items in the cupholder carefully as items may become loose during hard braking, acceleration or collisions, including hot drinks which may spill. Note: The appearance and features of the cen ...

Other materials:

Removal and Installation
Hood Latch Removal and Installation Remove the upper radiator sight shield. Remove the 8 screws. Remove the 4 bolts. Remove the 2 pin-type retainers. NOTE: Mark the position of the hood latch prior to removing the hood latch bolts.Remove the 2 bolts and position t ...

Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds): 1. Turn the ignition off. 2. Turn the lighting control to the autolamp position. ...

Installation
Engine Special Tool(s) Material All vehicles Using the Floor Crane and Spreader Bar, align the transaxle to the engine. Align the transaxle to the engine and install the 5 transaxle-to-engine bolts. Tighten to 48 Nm (35 lb-ft). Install the 2 engine-to-transaxle bolts. ...