Engine

...

Specifications, Description and Operation, Diagnosis and Testing

SPECIFICATIONS Material DESCRIPTION AND OPERATION Engine NOTICE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an eng ...

Other materials:

General Procedures
Camshaft Bearing Journal Diameter NOTE: Refer to the appropriate Section 303-01 for the specification. Measure each camshaft journal diameter in 2 directions. Camshaft Journal to Bearing Clearance - OHC Engines NOTE: Refer to the appropriate Section 303-01 for the specification. ...

Removal and Installation
Safety Belt Anchor and Pretensioner Special Tool(s) Removal and Installation  WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in ...

Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds): 1. Turn the ignition off. 2. Turn the lighting control to the autolamp position. ...