- Anti-Theft - Perimeter
- Anti-Theft - Passive Anti-Theft System (PATS), Without Intelligent Access (IA)
- Anti-Theft - Passive Anti-Theft System (PATS), With Intelligent Access (IA)
- Remote Convenience
- Cruise Control - Non-Adaptive
- Cruise Control - Adaptive
- Collision Avoidance
- Side And Rear Vision
- Lane Departure Warning
- Multifunction Electronic Modules
Module Configuration
DESCRIPTION AND OPERATION
Module Configuration
System Operation
Programmable Module Installation (PMI)
Programmable Module Installation (PMI) is a scan tool process which
configures settings in a new ...
Anti-Theft - Perimeter
DESCRIPTION AND OPERATION
Anti-Theft - Without Intelligent Access (IA)
Overview
The perimeter alarm system deters unauthorized entry to the vehicle by
sounding the horn and flashing all the turn sign ...
Other materials:
Diagnosis and Testing
Wheels And Tires
Special Tool(s)
Inspection and Verification
WARNING:
Vehicle may have multiple drive wheels. Do not use engine to power the driveline
unless all drive wheels are elevated off the ground. Drive wheels in contact
with ground could cause unexpected vehicle movement. Failure to foll ...
Specifications, Description and Operation
SPECIFICATIONS
Material
General Specifications
Torque Specifications
DESCRIPTION AND OPERATION
Wipers and Washers
Overview
The windshield wiper/washer system is activated by the wiper/washer controls
on the multifunction switch. The following functions/features of the windshield
wiper/washer sy ...
Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three
minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6
must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting control to the autolamp position.
...
