Rear Drive Halfshafts

SPECIFICATIONS Torque Specifications a Refer to the procedure in this section. DESCRIPTION AND OPERATION Rear Drive Halfshafts The halfshafts consist of the following components: Inner CV ...

Brake System - General Information

SPECIFICATIONS Material General Specifications Torque Specifications DIAGNOSIS AND TESTING Principles of Operation Brake System Applying the brake pedal uses lever action to push a rod into the bra ...

Other materials:

In-Vehicle Repair
Upper Intake Manifold Removal NOTICE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions c ...

Removal and Installation
Clockspring Removal and Installation  WARNING: If the clockspring is not correctly centralized, it may fail prematurely. If in doubt, repeat the centralizing procedure. Failure to follow these instructions may increase the risk of serious personal injury or death in a crash. NOTE: Remov ...

Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds): 1. Turn the ignition off. 2. Turn the lighting control to the autolamp position. ...