WARNING:
Do not let children play with the moonroof or leave children unattended in the vehicle. They may seriously hurt themselves.
WARNING:
When closing the moonroof, you should verify that it is free of obstructions and ensure that children and/or pets are not in the proximity of the moonroof opening.
You can manually open or close the sliding shade when the moonroof is closed. Pull the shade toward the front of the vehicle to close it.
The moonroof controls are located on the overhead console.
The moonroof has a one-touch open and close feature. To stop its motion during one-touch operation, press the control a second time.
Opening and Closing the Moonroof

Press and release the SLIDE control to open the moonroof.
Pull and release the SLIDE control to close the moonroof.
Bounce-Back
The moonroof automatically stops closing and reverses if it detects an obstacle while closing.
Pull and hold the SLIDE control within two seconds of a bounce-back event to override the function. The closing force begins to increase each of the next three times the moonroof close s, with bounce-back active.
Venting the Moonroof
Press and release the TILT control to vent the moonroof. Pull and hold the TILT control to close the moonroof.
Sunshade
The power rear sunshade covers the rear window of the vehicle.
The control is located in the center
console access bin.
Press the control to move the sunshade up or down.
Note: Do not try to m ...
Other materials:
General Procedures
Sectioning Guidelines
General Equipment
Material
NOTE: The following illustration provides recommended sectioning
points. Cut lines shown in illustration are approximate.
WARNING:
Collision damage repair must conform to the instructions contained in this
workshop manual. Replacement ...
Interior lamps
Front row map lamps
The map lamps are located on the
overhead console. Press the outer
edge of the clear lens to turn on the
lamps. The map lamps also light
when:
• any door is opened.
• the instrument panel dimmer
button is pressed until the
courtesy lamp comes on.
• the remot ...
Front Disc Brake
SPECIFICATIONS
Torque Specifications
REMOVAL AND INSTALLATION
Brake Pads - 325 mm (13 in) Brakes
Material
Removal
WARNING:
Before beginning any service procedure in this section, refer to Safety Warnings
in Section 100-00. Failure to follow this instruction may result in serious
personal i ...

