Ford Taurus Service Manual: Noise, Vibration and Harshness

Jacking and Lifting
 WARNING: When jacking or lifting the vehicle, block all wheels remaining on the ground. Set the parking brake if the rear wheels will remain on the ground. These actions help prevent unintende ...

Noise, Vibration and Harshness (NVH) - Description and Operation
Noise is any undesirable sound, usually unpleasant in nature. Vibration is any motion, shaking or trembling, that can be felt or seen when an object moves back and forth or up and down. Harshness is ...

Other materials:

Removal and Installation
Safety Belt Anchor and Pretensioner Special Tool(s) Removal and Installation  WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in ...

Electronic Engine Controls
SPECIFICATIONS Material  Torque Specifications a Refer to the procedure in this section. DESCRIPTION AND OPERATION Electronic Engine Controls Component Location PCM Location - 3.5L Ti-VCT, 3.7L Ti-VCT PCM Location - 2.0L GTDI, 3.5L GTDI Front Engine S ...

Driveline System - General Information
SPECIFICATIONS Material General Specifications DESCRIPTION AND OPERATION Driveline System The driveline system consists of the following components: Center support bearing Driveshaft assembly Front halfshafts Rear halfshafts Active Torque Coupling (ATC)/rear axle On Front Wheel Drive (FWD ...