Brake Shift Interlock Override - Floor Shift
NOTE: If it is necessary to use the override procedure to move the selector lever out of the PARK position, it is possible that a fuse has blown. GO to Pinpoint Test A.
This vehicle is equipped with a brake shift interlock feature that prevents the selector lever from being moved out of PARK when the ignition is in the ON position until the brake pedal is applied.
If the selector lever cannot be moved out of the PARK position when the ignition is in the ON position and the brake pedal is applied:
- Apply the parking brake. Turn the ignition key to the off position and remove the key.
- Push the brake shift interlock override mechanism on the selector lever forward, apply the brake, press the button on the selector lever and move the selector lever into NEUTRAL.
- Start the vehicle.
- For assembly, reverse the procedure.
Selector Lever Cable Adjustment - 6F35
-
- Rotate the manual control lever clockwise until it stops.
- Rotate the manual control lever counterclockwise 1 detent.
-
- Carefully pry outward the adjuster lock tabs.
- While holding the adjuster lock tabs outward, slide the lock to unlock the selector lever cable.
- NOTICE: To prevent selector lever cable damage, do not apply
force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: Make sure that the selector lever cable end is correctly installed onto the manual control lever ball stud by pulling back on the selector lever cable end.
- NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed.
- Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.
Selector Lever Cable Adjustment - 6F50/6F55
- Remove the ACL and outlet pipe. Refer to Section 303-12.
-
- Rotate the manual control lever clockwise until it stops.
- Rotate the manual control lever counterclockwise one detent.
-
- Gently pry the latch up.
- Push the lock tab to slide it over.
- NOTICE: To prevent selector lever cable damage, do not apply
force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: Make sure that the selector lever cable end is correctly installed onto the manual control lever ball stud by pulling back on the selector lever cable end.
- NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed.
- Install the ACL and outlet pipe. Refer to Section 303-12.
- Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.
Diagnosis and Testing
External Controls Inspection and Verification Verify the customer concern by operating the system. Visually inspect for obvious signs of mechanical or electrical damage. If the concern is not ...Removal and Installation
Selector Lever Cable - Floor Shift Removal All vehicles With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02. NOTICE: Failure to use a piece of c ...Other materials:
In california (U.S. ONLY)
California Civil Code Section 1793.2(d) requires that, if a manufacturer
or its representative is unable to repair a motor vehicle to conform to
the vehicle’s applicable express warranty after a reasonable number of
attempts, the manufacturer shall be required to either replace the
vehicle wit ...
Appendices
GENERAL INFORMATION
SYNC® End User License Agreement (EULA)
• You have acquired a device (“DEVICE”) that includes software
licensed by Ford Motor Company and its affiliates (“FORD MOTOR
COMPANY”) from an affiliate of Microsoft Corporation (“MS”). Those
installed software products ...
Front passenger sensing system
WARNING: Even with Advanced Restraints Systems, children 12
and under should be properly restrained in a rear seating
position. Failure to follow this could seriously increase the risk of injury
or death.
WARNING: Sitting improperly out of position or with the seat
back reclined too far can tak ...