SPECIFICATIONS
Material
General Specifications
Torque Specifications
DESCRIPTION AND OPERATION
Engine Ignition
Component Location
System Operation
REFER to the PC/ED manual section 1 Description and Operation.
Component Description
REFER to the PC/ED manual section 1 Description and Operation.
DIAGNOSIS AND TESTING
Engine Ignition
For PCM DTCs, REFER to Section 303-14 PCM DTC Chart. For driveability symptoms without DTCs, refer to the PC/ED manual, section 3 Symptom Charts.
REMOVAL AND INSTALLATION
Ignition Coil-On-Plug
Material
Removal and Installation
NOTE: Removal steps in this procedure may contain installation details.
- Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Section 303-12.
-
- Tighten to 5 Nm (44 lb-in).
NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
NOTE: When installing apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.
-
- Tighten to 8 Nm (71 lb-in).
- Inspect the ignition coil-on-plug rubber boot assembly for cracks, rips, or tears. Replace any damaged coil-on-plug rubber boots. Visual check.
- To install, reverse the removal procedure.
Spark Plugs
Removal and Installation
NOTE: Removal steps in this procedure may contain installation details.
- Remove the 4 ignition coil-on-plugs. For additional information, refer to Ignition Coil-On-Plug in this section.
- NOTICE: Only use hand tools when removing or installing the
spark plugs, or damage can occur to the cylinder head or spark plug.
NOTICE: The spark plug procedure must be followed exactly or damage to the cylinder head and spark plug will result.
NOTICE: Do not remove the spark plugs when the engine is hot or cold soaked. Spark plug thread or cylinder head damage can occur. Make sure the engine is warm (hand touch after cooling down) prior to spark plug removal.
NOTE: Used compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
Remove the 4 spark plugs.- Tighten to 12 Nm (106 lb-in).
- Inspect the 4 spark plugs. For additional information, refer to Section 303-00.
- To install, reverse the removal procedure.
Engine Ignition - 3.5L GTDI
SPECIFICATIONS Material General Specifications Torque Specifications a Refer to the procedure in this section. DESCRIPTION AND OPERATION Engine Ignition 3.5L GTDI System Operation R ...Engine Ignition - 3.7L Ti-VCT
SPECIFICATIONS Material General Specifications Torque Specifications DESCRIPTION AND OPERATION Engine Ignition Component Location 3.7L Ti-VCT System Operation REFER to the PC/ED m ...Other materials:
SecuriLock® passive anti-theft system
Note: The system is not compatible with non-Ford aftermarket remote
start systems. Use of these systems may result in vehicle starting
problems and a loss of security protection.
Note: Metallic objects, electronic devices or a second coded key on the
same key chain may cause vehicle starting i ...
Dual automatic temperature control
Note: You can switch temperature units between Fahrenheit and Celsius.
See Menu features in the MyFord Touch or MyLincoln Touch chapter.
A. Power/Driver temperature control: Press to turn the climate
control system off and on. When the system is off, outside air cannot
enter the vehicle.
...
Tire care
Information About Uniform Tire Quality Grading
Tire Quality Grades apply to new
pneumatic passenger car tires. The Tire
Quality Grades can be found where
applicable on the tire sidewall between
tread shoulder and maximum section
width. For example:
• Treadwear 200 Traction AA Temperature ...