WARNING:
Do not adjust the steering wheel when your vehicle is moving.
Note:
Make sure that you are sitting in the correct position. See Sitting in the Correct Position in the Seats chapter.
1. Unlock the steering column.
2. Adjust the steering wheel to the desired position.
3. Lock the steering column.
Power Tilt and Telescope Steering Column (If Equipped)
WARNING:
Do not adjust the steering wheel when your vehicle is moving.
Note:
Make sure that you are sitting in the correct position. Refer to Sitting in the Correct Position in the Seats chapter.
Use the control on the side of the steering column to adjust the position.
To adjust: • tilt: press the top or bottom of the control
telescope: press the front or rear of the control.
Easy Entry and Exit Feature
When you switch the ignition off, the steering column will move to the full up and forward position to allow extra room to exit your vehicle.
The column will return to the previous setting when you switch the ignition on. You can enable or disable this feature in the information display. See General Information in the Information Displays chapter.
Memory Feature
You can save and recall the steering column position with the memory function. Refer to the Seats chapter.
Pressing the adjustment control during memory recall cancels the operation. The column responds to the adjustment control.
The steering column sets a stopping position just short of the end of the column position to prevent damage to the steering column. A new stopping position sets if the steering column encounters an object when tilting or telescoping.
To reset the steering column to its normal stopping position: 1. Press the steering column control again after encountering the new stopping position.
2. Continue pressing the control until it reaches the end of the column position.
A new stopping position is set. The next time you tilt or telescope the steering column, it will stop just short of the end of the column position.
Steering Wheel
...Steering wheel controls
AUDIO CONTROL SEEK: Press to select the next or previous stored preset or track. Press and hold to select the next or previous frequency or seek through a track. MEDIA: Press repeatedly to ...Other materials:
Fuel Charging and Controls - 3.7L Ti-VCT
SPECIFICATIONS
Material
Torque Specifications
DESCRIPTION AND OPERATION
Fuel Charging and Controls
Component Locations
WARNING: Do
not smoke, carry lighted tobacco or have an open flame of any type when working
on or near any fuel-related component. Highly flammable mixtures are always
present ...
Removal and Installation
Block Heater - 2.0L GTDI
Removal
NOTE: Removal steps in this procedure may contain installation
details.
Drain the cooling system. For additional information, refer to Cooling
System Draining, Filling and Bleeding in this section.
NOTICE: To install, route the block heate ...
Remote Convenience
DESCRIPTION AND OPERATION
Universal Transmitter
Overview
The universal transmitter operates garage doors, gates and home or office
lighting and security systems.
System Operation
Universal Home Transmitter
The universal transmitter learns a hand-held transmitter radio frequency code
and stores the ...