- Specifications, Description and Operation
- Diagnosis and Testing
- General Procedures
- Removal and Installation
General Procedures, Removal and Installation
GENERAL PROCEDURES
Wiper Blade and Pivot Arm Adjustment
Cycle and park the windshield wipers.
Verify that the RH and LH wiper blade tips are aligned to the "I" marks
on the lower windshield gla ...
Specifications, Description and Operation
SPECIFICATIONS
General Specifications
Torque Specifications
DESCRIPTION AND OPERATION
Roof Opening Panel
The roof opening panel system consists of:
Roof opening panel air deflector
Roof opening p ...
Other materials:
Cruise Control - Adaptive
SPECIFICATIONS
Torque Specifications
DESCRIPTION AND OPERATION
Cruise Control
Component Location
C-CM
HUD module
Overview
The adaptive cruise control system is controlled by the steering wheel
mounted switches (ON/OFF, SET, CNCL, RES and GAP) that are integrated into the
LH steerin ...
Vehicle certification label
The National Highway Traffic Safety
Administration Regulations require
that a Safety Compliance Certification
Label be affixed to a vehicle and
prescribe where the Safety
Compliance Certification Label may
be located. The Safety Compliance
Certification Label shall be affixed to
either the ...
General Procedures
Valve Clearance Check
Remove the RH fender splash shield. For additional information, refer
to Section 501-02.
Remove the valve cover. For additional information, refer to Valve
Cover in this section.
NOTE: Turn the engine clockwise only, and only use the crankshaft
...
